以前新車為什么要磨合1：讓發動機、變速器的各齒輪進行磨合，以達到*佳的工作狀況；2：讓剎車系統充分磨合，以達到*佳的工作狀況；3：讓車主與新車進行磨合，熟悉車輛性能，減少事故發生；總結起來就是，新車磨合就是為了消除零部件在制造過程中出現的幾何偏差，讓零件配合更完美，性能達到*佳。如今，汽車制造工藝及零件加工精度已有了質的提升，那么，新車到底還需不需要磨合呢？答案是：當然要
Before the new car why to run in 1: let the engine, gear gear grinding, in order to achieve the best working conditions; 2: let the brake system fully run in, to achieve the best working conditions; 3: let the owner and new car run in, familiar with vehicle performance, reduce accidents; summing up is the new car running in. It is to eliminate the geometric deviations of parts in the manufacturing process, so that the parts can be more perfectly matched and the best performance can be achieved. Now, the accuracy of automobile manufacturing technology and parts processing has been improved. So, do new cars need to run in anyway? The answer is: of course
1：在100-500公里時,新車磨合期車速不宜過快,一般控制在50-90 km/h之間，有些車型可稍高些，磨合期*高車速可以控制在110km/h以內。2：另外就是控制發動機的轉速，一般轉速*控制在2000-2500轉，千萬注意不要讓發動機在高,應溫和駕駛,新車磨合期時速不超過100公里,轉速不超過2500轉.3：到前2500-3500公里,水溫已達工作
1: at 100-500 km, the speed of the new car should not be too fast in the running in period. The general control is between 50-90 km/h, some cars can be slightly higher, and the maximum speed in the running in period can be controlled within 110km/h. 2: the other is to control the engine speed, the general speed of the best control in the 2000-2500 turn, do not let the engine in high, should be gentle driving, the new car running in period is not more than 100 kilometers, the speed does not exceed 2500.3: to the first 2500-3500 kilometers, the water temperature has reached work
濟南陸通汽車是一家集進口國產高端轎車，越野車、城市SUV，診斷 ，維修與保養及配件供應與一體的專業性汽車售后服務中心，本中心擁 有高端車專用檢測設備，主營：進口國產 寶馬、奔馳、大眾、奧迪、 沃爾沃等高端車診斷維修與保養服務(德系專修）。
公司以顧客至上，誠信為本 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。