根據焊槍的擺動方式,焊接擺動器可以分為直線擺動方式(俗稱直擺型)和焊槍沿圓弧方向擺動方式(俗稱鐘擺型)。
According to the swing mode of welding gun, welding oscillator can be divided into linear swing mode (commonly known as straight pendulum type) and welding torch swing along the circular direction (commonly known as pendulum type).
把焊接擺動器固定在小車上,通過擺動小車控制箱的控制電路來控制行走電機,使小車沿焊縫方向前后走動。
The welding swing device is fixed on the trolley, and the control circuit of the control box is controlled by the swing car, so that the car can move forward and backward along the welding direction.
焊接擺動器上裝有限位開關,限位開關用于當焊槍到達極限位置時,產生信號并傳給單片機控制系統,使控制系統作出相應的控制,來控制焊接擺動器的*大擺幅,保護步進電機。限位開關另外的作用是使焊槍對中復位。
山東自動焊接設備
The welding oscillator is provided with a limited switch, limit switch is used when the torch reaches the limit position when the signal is generated and passed to the microcomputer control system, the control system to make the corresponding control, to control the welding oscillator swing, stepper motor protection. The limit switch is in effect to make the welding torch in reset.
通過限位開關的狀態和面板設定狀態來控制步進電機控制器,從而達到控制焊槍擺動的目的。
To control the stepper motor controller through the limit switch state and panel set state, so as to achieve the purpose of controlling the welding torch swing.
通過擺動小車控制箱的控制板和C仇氣體保護焊機之間的RS485通信接口,可以遠程調節焊機的焊接參數,方便工人操作。該系統可以實現焊機、行走電機、擺動電機以及送絲電機的同步控制。
The welding parameters of the welding machine can be adjusted remotely through the RS485 communication interface between the control panel and the C gas protection welding machine, which is convenient for workers to operate. The system can realize the synchronous control of welding machine, walking motor, swing motor and wire feeding motor.
泰安揚帆數控科技有限公司(咨詢電話 0538－5358300)座落在風景秀麗的泰山腳下，東平湖畔。東臨泰山，西依黃河，南與孔孟故里 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。