設焊接專機主要配置及功能：
The main configuration and function of welding machine:
1、床身結構：焊接結構，保證工件旋轉直徑和床身的強度。床身進行熱處理。焊槍相對固定，工件旋轉，焊接位置水平。工件由三爪卡盤夾緊隨動，中間有升降支撐機構。
1, bed structure: welding structure, ensure the strength and the diameter of the workpiece rotation. The bed of heat treatment. The torch is relatively fixed, the workpiece rotation, horizontal position welding. Three jaw chuck clamping workpiece by servo, the middle lifting supporting mechanism.
2、主軸箱：主軸帶有間隙微調裝置，以便于軸承磨損后有效調節主軸跳動，主軸徑向與端面跳動＜0.15mm。尾座與主軸同軸度＜0.15mm。
2, the spindle box: spindle with clearance adjustment device, in order to facilitate the adjustment of the spindle bearing wear after the spindle runout, radial and end face runout 0.15mm. The coaxial degree of tailstock and spindle 0.15mm.
3、工件支撐：采用直線導軌，個工件手工調整位置以及高度，調整后自動控制上升和下降。工件支撐機構可沿導軌縱向移動，以適應不同長度工件的焊接。
3, the workpiece support: the use of linear guide, manual adjustment of the position and height of the workpiece, adjusted to automatically control the rise and fall. The workpiece supporting mechanism can move along the longitudinal direction of the guide rail to adapt to the welding of workpieces with different lengths.
4、焊槍系統：電機驅動（自動/手動），每一圈上升高度可調，焊槍角度可調，焊槍微調，焊槍左右可移動。
4, the torch system: motor drive (automatic / manual), each lap welding torch height adjustable, adjustable angle, welding torch can move about fine-tuning.
5、擺動系統：焊槍要有擺動和提升功能，來實現在焊接過程中焊槍的自動提升和擺動，以完成多層焊，填滿焊道。擺動速度:0～100回每分鐘。擺動范圍:0～25mm。
5, the system should have: welding torch swing swinging and lifting function, to achieve automatic lifting and swing in the process of welding torch, to complete the welding, weld fill. Swing speed: 0 to 100 minutes per minute. Swing range: 0 ~ 25mm.
泰安揚帆數控科技有限公司（13345281377）主要產品有焊接自動化成套裝備、數控切割機、工業焊接機器人和數字化逆變焊接電源、焊縫跟蹤系統及焊接擺動器 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。