 |
膠水公司
| 聯系人：王小姐
女士 (主管) |
| 電 話：021-51693135 |
手 機：13052326431  |
 |
|
 |
|
| MULTICORE 381電子組裝/工業膠水/電子組裝膠水/工業用膠 |
MULTICORE 381電子組裝/工業膠水/電子組裝膠水/工業用膠
技術服務熱線：021-51693135 / 021-22818476
PRODUCT DESCRIPTION
Ersin Multicore™ 381 is a rosin-based mildly activated flux
formulated to complement wave and reflow soldering
processes.
RECOMMENDED OPERATING CONDITIONS
Soldering with ERSIN 381 is convenient as it does not call for
any special methods or deviation from the normal hand
soldering practices.
Soldering Iron: Good results should be obtained using a
range of tip temperatures. However, the optimum tip
temperature and heat capacity required for a hand-soldering
process is a function of both soldering iron design and the
nature of the task. Care should be exercised to avoid
unnecessarily high tip temperatures for excessive times. The
tip of the soldering iron should be properly tinned. Severely
contaminated soldering iron tips should be cleaned with
Multicore Tip Tinner/Cleaner.
Soldering Process: Best results will be obtained if the
following recommended operating practice is followed.
a) Apply the soldering iron tip to the work surface. The
iron tip should contact both the base material and the
lead at the same time to heat both surfaces properly. It
should take no more than a fraction of a second to heat
both surfaces adequately.
b) At this time the ERSIN 381 flux cored wire should be
applied to a part of the joint surface away from the
soldering iron and allowed to flow to form the joint
fillet. This will be virtually instantaneous. Do not
apply excessive solder to the joint as this will not
improve joint integrity and it will leave excess flux
residues on the surface.
c) Remove solder from the work piece and then remove
the iron tip.
This total process will be very rapid, depending upon
thermal mass, tip temperature, tip configuration and the
solderability of the surface to be joined.
產品描述
Ersin Multicore™381是一種基于松香的輕度活化的助焊劑
配制為補波和回流焊
過程。
推薦操作條件
使用ERSIN 381焊接方便，因為它不需要
任何特殊的方法或偏離正常的手
|
 |
| |
|
|
 |
|
|
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。