路博潤ESTANE R190A TPU
Technical Data Sheet Type: ESTANE? R190A is a Shore 93A, polyether type thermoplastic polyurethane (TPU). Uses: Injection Molding, Extrusion *Test samples were annealed at 100°C and 24 hours at room temperature before testing. **These are typical values and should not be used for specifications. Injection Molding Guide ? These settings are to be used only as a guide. This is a typical injection molding temperature profile based on the Test Machine (conditions based on a 75 ton machine with a general purpose screw – L/D 17 – ? 35mm). The optimal run conditions for specific equipment will vary depending on the machine and mold design. Physical Properties Value (Metric) Unit Test Method Hardness 93 47 Shore A Shore D ASTM D2240 Specific Gravity 1.11 g/cm3 ASTM D792 Mechanical Tensile Stress: kgf/cm2 ASTM D412 - 100 % Elongation 100 - 300 % Elongation 170 Tensile Strength 370 kgf/cm2 ASTM D412 Ultimate Elongation 680 % ASTM D412 Tear Resistance (Die C) 110 kgf/cm ASTM D624 Abrasion Loss 25 mm3 loss ISO 4649 Compression Set ASTM D395 At 23°C X22hr 15 % At 70°C X22hr 45 % Mold Shrinkage 0.007 m/m ASTM D955 Thermal Vicat Softening Temperature 125 °C ASTM D15 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。