路博潤ESTANE T370A TPU
Type: Estane? T370A is a Shore 74A, polyether grade, plasticizer-free, with low hardness thermoplastic polyurethane (TPU). Uses: Injection Molding, Extrusion *Test samples were annealed at 100o C and 24 hours at room temperature before testing. **These are typical values and should not be used for specifications. Injection Molding Guide These settings are to be used only as a guide. This is a typical injection molding temperature profile based on the Test Machine (conditions based on a 75 ton machine with a general purpose screw – L/D 17 – ? 35mm). The optimal run conditions for specific equipment will vary depending on the machine and mold design. Drying Conditions Physical Properties Standard No. Units Value Hardness ASTM D2240 Shore A 75 Specific Gravity ASTM D792 g/cm3 1.06 Mechanical Tensile Stress: ASTM D412 kgf/cm2 At *** elongation 32 At 300% elongation 57 Tensile Strength ASTM D412 kgf/cm2 250 Ultimate Elongation ASTM D412 % 900 Tear Resistance (Die C) ASTM D624 kgf/cm 70 Compression Set ASTM D395 At 23°C X22hr % 10 At 70°C X22hr % 30 Mold Shrinkage ASTM D955 m/m 0.006 Thermal Vicat Softening Temperature ASTM D1525 °C |
免責聲明：以上所展示的信息由會員自行提供，內(nèi)容的真實性、準確性和合法性由發(fā)布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。