HYSOL PC62電子組裝/工業膠水/電子組裝膠水/工業用膠
技術服務熱線：021-51693135 / 021-22818476
PC62 conformal coating is a rapid drying acrylic for circuit board protection.
TYPICAL PROPERTIES OF UNDRIED MATERIAL Viscosity, Brookfield - LV, 25 °C, cps:Spindle 1, speed 30 rpm 40 to 65Specific Gravity @ 25oC 0.81 to 0.83Tack Free Time:~25°C/~35% RH (120μm wet film), minutes <5Flash Point - See MSDSTYPICAL DRYING PERFORMANCE Recommended Drying Conditions24 hours @ 25°CAlternative Drying Conditions45 minutes @ 75°CDrying of the coating depends upon solvent evaporation.
For optimum performance, boards should be dried at least 30 minutes at 25°C to remove solvents before final drying in oven (or before applying additional coats).
Drying temperatures higher than recommended could cause formation of bubbles if bulk solvent is not allowed to evaporate before placing in oven.
Optimization of the drying schedule may be possible to reduce the times stated above. Ultimately, drying times will depend on film thickness and circuit board design.
It is therefore imperative to verify the drying schedule for each applications.
Desecration is not suggested due to a risk of solvent lossSTORAGEStore product in the unopened container in a dry location. Storage information is indicated on the product containerlabeling.
Optimal Storage: 5°C to 30°C. Storage below 5°C or greater than 30°C can adversely affect product properties.
PC62保形涂層是用于電路板保護的快速干燥丙烯酸
物理性質：Brookfield-LV，25℃，cps：主軸1，速度30rpm 40至65特定重力@ 25℃0.81至0.83釋放時間：〜25° C /〜35％RH（120μm濕膜），分鐘<5閃點 - 參見MSDSTYPICAL DRYING PERFORMANCER推薦的干燥條件24小時25°CA替代品干燥條件75分鐘@ 75°涂層取決于溶劑蒸發。對于*佳性能，板應在25°C下干燥至少30分鐘，以在*后干燥之前（或在施加額外的涂層之前）除去溶劑。如果散裝溶劑在放入烘箱之前不允許散裝，則高于推薦的溫度會導致氣泡的形成。干燥時間的優化可以減少上述時間。
*后，干燥時間取決于膜厚度和電路板設計。
因此，必須驗證每個應用程序的干燥時間表。
由于存在溶劑損失的風險，因此不清潔脫水STORAGE Store產品在未開封的容器中，在干燥的位置。儲存信息在產 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。