環氧膠 漢高漢高樂泰樂泰 Ablestik 2332 HF
技術服務熱線：021-51693135 / 021-22818476
Ablestik 2332 HF
樂泰 ABLESTIK 2332-17U is a solventless epoxy adhesive that develops high bond strength when cured at temperatures as low as 100 to 130°C.
TYPICAL PROPERTIES OF UNCURED MATERIAL
Viscosity @ 25 °C, mPa∙s (cP) 100,000
Specific Gravity @ 25oC 1.16
Shelf Life @ 0 to 4°C, days 182
Flash Point - See SDS
TYPICAL CURING PERFORMANCE
Cure Schedule
1 hour @ 120°C
Alternative Cure Schedule
90 minutes @ 100°C
30 minutes @ 120°C
20 minutes @ 150°C
樂泰 ABLESTIK 2332-17U may also be cured in paint ovens at temperatures above 130oC.
The above cure profiles are guideline recommendations. Cure conditions (time and temperature) may vary based on customers' experience and their application requirements, as well as customer curing equipment, oven loading and actual oven temperatures.
TYPICAL PROPERTIES OF CURED MATERIAL
Physical Properties
Hardness, Shore D:
@ 25oC , minimum 75
TYPICAL PERFORMANCE OF CURED MATERIAL
Tensile Lap Shear Strength:
Al to Al :
@ 25°C N/mm2 24
(psi) (3,500)
樂泰 ABLESTIK 2332-17u是無溶劑環氧膠粘劑的粘接強度高，固化后形成在溫度低至100到130°C.
固化材料的典型性能
粘度@ 25°C，MPA∙S（CP）100000
比重@ 25oC 1.16
保質期@ 0至4°C，天182
閃點-見SDS
典型的固化性能
治療計劃
1小時@ 120°C
替代治療計劃
90分鐘@ 100°C
30分鐘@ 120°C
20分鐘@ 150°C
2332-17u 樂泰 ABLESTIK可固化油漆爐在130以上oC.溫度
上述固化型材指南建議。固化條件（時間和溫度）可能會根據客戶的經驗和他們的應用要求，以及客戶固化設備，烘箱負荷和實際烤箱溫度變化。
固化材料的典型性能
物理性質
Shore D硬度：
“25oC，*低75
固化材料的典型性能
拉伸搭接剪切強度：
鋁對鋁：
“25°C N / mm224
（PSI）（3500） |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。