原裝進口松下底填膠CV5300AK01EPS耐高溫芯片倒裝底填膠
Liquid encapsulant materials
CV5300AK
TECHNICAL INFORMATION
Encapsulation Materials Department Plastic Materials Business Unit Electronic Materials Business Division
Panasonic Industory Co., Ltd
This is one component epoxy for Flip-chip underfilling.
TYPICAL PROPERTIES
Properties Unit Data Test Method
Viscosity(25oC) Pa*s 20 KES-B-0102
Gelation time sec 800 EKS-B-1051
RECOMMENDING PREHEAT CONDITION
temperature of substrate : 80～120oC
temperature of syringe : R.T.～ 60oC
TYPICAL CURED PROPERTIES
Measurement Cure Conditions : 100'C2hour + 150`C 2hour
Treatment Conditions
(A):PCT with 10% water for 20hrs resin was cured and crushed
※Typical data
ATTENTION TO STORAGE
・Stored compound must be thawed before use. Warm at room temperature until no longer cool to touch (about 2hrs).
・Please use up the material within 12 hrs.
・Compound must be stored in the cool condition with sealing.
・Please keep material under -40oC after receiving product.
ATTENTION TO HANDLING
・Please avoid direct contact with this product by wearing gloves, protecting gears,etc.
・Prevent frequent skin contact. If contact occurs, wash immediately with soap and water.
原裝進口松下底填膠CV5300AK01EPS耐高溫芯片倒裝底填膠
上海金泰諾材料科技有限 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。