TYPICAL USES
Sandstrom LC-300 is an excellent solution to the problem of
lubricating parts:
?Where "clean operation" is desired (LC-300 will not collect dirt and
debris as do grease and oils)
?Where parts may be subjected to frequent disassembly
?Where a protective coating and sacrificial break-in lubricant are
needed
?Where fretting and galling is a problem (such as splines, universal
joints, and keyed bearings)
?Where easy release is desired (such as acme nuts and screws
and PVC molds)
?Where metallurgical properties are adversely affected by baking
at temperatures higher than 300oF
?That will be operated in corrosive atmospheres
?That may be stored for long periods
?Which are seldom lubricated once they leave the factory and
where permanent lubrication is desired
?Where operating pressures exceed the load-bearing capacities of
ordinary oils and grease |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。