除日常性保養各項目外,重點應檢查各部件的磨損情況
In addition to the daily maintenance items, the emphasis should be given to the inspection of the wear conditions of the components.
1、檢查上、下機架、主機底盤、上料皮帶機、限位開關等部位的聯接螺栓是否有松動現象,各腳板是否有松動,基礎是否下沉.
1, check whether the connecting bolts on the upper and lower rack, main chassis, loading belt conveyor, limit switch and other parts are loose, whether the footboards are loose or not, and whether the foundation sinks.
2、檢查襯板、葉片磨損情況,有松動、開裂、磨去1/2等情況時,應及時更換;葉片與拌筒間間隙過大,則調整至3-8mm.
2, check the lining plate, blade wear, loose, cracking, abrasion 1/2 etc., should be replaced; and the drum blade between the gap is too large, it is adjusted to 3-8mm.
3、檢查各減速機內潤滑油情況,按常規方法及配套件說明書更換潤滑油.
3. Check the lubricating oil in each reducer and replace the lubricating oil according to the routine method and the instructions of the supporting parts.
4、檢查皮帶的磨損情況(一般情況下,皮帶可使用達到12個月以上),若有磨損嚴重則及時更換新帶,其長度見易損件清單.
4, check the wear condition of the belt. (usually, the belt can be used for more than 12 months). If there is serious wear, the new belt will be replaced in time. The length of the belt can be seen on the list of vulnerable parts.
5、檢查各骨料倉底部開門板的磨損情況,若磨損嚴重,如穿孔、漏料,則及時更換新門板,現場焊上.
5. Check the wear of the bottom plate of the aggregate barn. If the wear is serious, such as perforation and leakage, the new door plate is replaced in time, and the spot is welded on the spot.
6、拆卸粉料斗的蝶閥,清理干凈內雜物并檢查內部橡膠板是否有損壞.
6, remove the butterfly valve of the powder hopper, clean up the sundries and check whether the internal rubber plate is damaged.
公司名稱：濟南笨鳥先飛自流平服務中心
聯系人：騰師傅
聯系電話1：18560146326
聯系電話2：13688634565
固定電話：0531-58969192
地址：濟南市各地均可服務
諾商基于多年的優化經驗和品牌基礎推出的諾商商道系統，諾商信息您身邊的互聯網專家！ |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。