DX1230裝配體的詳細資料：
端面銑床由以下幾部分構成：Face milling machine consists of the following sections
1. 床身:端面銑床床身分為雙矩形導軌和一矩一V合組形導軌兩種,床身導軌面都經過超音頻淬火處理,深度為3-5毫米,硬度為HRC-52.耐磨性能好,使用壽命長.
Lathe bed ：face milling machine lathe bed is divided into double rectangular guideway and a rectangular and a V composite guideway，Lathe bed guide surface get through super audio quenching processing，the depth is3-5mm，the hardness is HRC-52，the machine has excellent wearability and long life.
2. 工作臺:工作臺采用優質耐磨鑄鐵鑄造而成，精加工后，采用手工鏟刮與導軌面配鏟而成。工作臺的進給采用變頻器，實現無級變速。
Worktable:worktable is made of high quality cast iron , after finishing, adopts manual shovel scraping and guide surface scraping，worktable feed adopts frequency converter, achieve stepless variable speed.
立柱：立柱的導軌是采用一高一矮兩條矩形導軌組合而成。其高導軌高出矮導軌55毫米，結合面積大，穩定性能高，剛性好。采用超音頻淬火處理，硬度耐磨性能好。工件高度不受機床限制，可垂直上下銑削。
Column：column guide adopts two rectangular guideways(one is high,the other is short). the high guideway is 55mm higher than the short one, the large guide surface, high stability, good rigidity.it Is made of super audio quenching treatment, the hardness wear-resisting performance is good. Workpiece height without being limited by the machine, vertical milling,it can work in vertical way(up and down)
4.橫向床身：橫向床身是在水平面上垂直與主床身，沿垂直與主床身中心線在水平面作前后運動。具有銑削寬廣的特點。由減速電機帶動絲杠螺母運動。
5. 主軸：擁有獨立進給系統，進給速度由變頻器控制，可根據工件不同材質，調節鏜孔(鉆孔)速度。 其中自動進給可選300/460/600mm，手動微調為150mm |
 |
|
手機站
您當前位置是：商業機會 >> 機械及行業設備 >> 其他未分類 >> 供應端面銑床數控端面銑床機加工端面銑床
聯系信息