1、防水材料防水層過薄：山東防水材料防水層必須達到一定的厚度才有防水效果，因為防水材料本身仍有較低的吸水特性，倘若防水層厚度不足，經過連日的滂沱大雨，雨水透過防水材料防水層至底部，經由好天氣的日照，仍會在底部產生水蒸氣，造成防水層剝離。*好能在所有的轉角處黏貼玻纖網格布進行增強處理，以防止防水材料防水層斷裂造成滲漏。
A級防火保溫材料
1, the waterproof material layer is too thin: Shandong waterproof material waterproof layer must reach a certain thickness is waterproof effect, because the waterproof material itself is still relatively low absorption characteristics, if the thickness of waterproof layer, after several days of torrential rain, rain through the waterproof material waterproof layer to the bottom, with good weather in Rizhao, will the steam generated in the bottom, causing the waterproof layer peeling. The best enhancement in the corner all adhesive fiberglass mesh cloth, waterproof material waterproof layer to prevent leakage caused by fracture.
2、底層未清潔干凈：因為在防水材料施工之前，必須將素地面清潔干凈，且盡量不要有粉塵與松動物質，否則就會出現防水層與基層黏結不牢固的現象，留下滲漏隱患。
2, the bottom is not clean, because before the construction of waterproof material, must be in the ground clean, and avoid dust and loose material, otherwise there will be between the waterproof layer and the base is not firm phenomenon, cause leakage.
3、底層有水氣：因為山東防水材料為油性的防水材料，所以在施作前必須確認素地是否干燥，否則防水做完后，水氣被包裹在里面，經由日照轉換成強大力量的蒸汽，將造成的剝離。
3, the bottom water: because Shandong waterproof material waterproof material is oily, so in the construction must be confirmed before the ground is dry, otherwise waterproof finish, moisture is wrapped inside, through the steam into sunshine power, it will cause peeling.
4、施工經驗不足：山東防水材料的施工*好由防水專業施工隊伍進行操作，不能去五金建材行隨便買些防水材料來涂。防水施作之前需仔細判斷滲漏原因，再加以解決。 |
 |
|
手機站
您當前位置是：商業機會 >> 建筑、建材 >> 耐火、防火材料 >> 防水失敗的主要原因出現在哪？
聯系信息