填縫劑的黏合性非常的強，收縮比較小，顏色的固著力強。為了讓填縫劑的作用發(fā)揮到*大效果，所以我們就需要注意A級防火保溫板施工的一些事項。
A級防火保溫材料
Very strong adhesive sealant, shrinkage is relatively small, the color of the solid strength. In order to make the sealant function to the maximum effect, so we need to pay attention to some matters a fireproof insulation board construction.
1、填縫劑在A級防火保溫板施工七天后方可施工，施工溫度不可低于0度。
1, sealant in a fireproof insulation board construction seven days before construction, construction temperature not lower than 0 degrees.
2、在*初的72小時內，必須注意防止填縫劑干燥（特指室外暴露于陽光下的施工面），此時可用天然牛皮紙覆蓋施工面（*好不要用塑料布或報紙?zhí)娲苑乐蛊渌┕ぷ鳂I(yè)把新做好的連接縫弄臟。
2, in the first 72 hours, must pay attention to prevent the sealing agent drying (especially the outdoor construction surface exposed to the sun), available at the time of natural kraft paper covering the construction surface (preferably not replaced with plastic cloth or newspaper), to prevent other construction work to do the dirty seam connection.
3、必須將裂縫表面或A級防火保溫板表面及連接縫清理干凈，用濕布將其表面弄濕，但不要留積水，以減少裂縫上的小孔吸入顏料和水泥，并且保證其著色和*終凝結度。
3, must be the surface cracks or a fireproof insulation board surface and the seam is clean, use a damp cloth to the surface wet, but do not leave the water, to reduce the hole crack inhalation paint and cement, and ensure the coloring and final condensation degree.
4、為了有助于控制顏色和減少粉化，在1-2小時內使用棉布或清潔的干毛巾擦拭表面即可。
4, in order to help control color and reduce the powder, in 1-2 hours, use cotton cloth or clean dry towel to wipe the surface |
 |
|
手機站
您當前位置是：商業(yè)機會 >> 建筑、建材 >> 耐火、防火材料 >> 對于A級防火保溫板固件的安裝細節(jié)
聯(lián)系信息