一 產品介紹
全鋼焊接結構，具有足夠的強度與剛性。液壓上傳動；
具有快速接近、加壓、卸壓快速退回功能；
滑塊同步采用抗扭連桿和機械擋塊機構；
折彎角度，后擋料距離采用電動調節，手動微調，數字顯示；根據用戶需要可加裝數控裝置。
折彎機機維護保養的方法
1、嚴格按照操作規程進行操作。
2、每次開機前按潤滑圖表要求定時、定點、定量加潤滑油，油應清潔無沉淀。
3、機床必須經常保持清潔，未油漆的部分應涂抹防銹油脂。
4、電動機軸承內的潤滑漾油要定期更換加注，并經常檢查電器部分工作是否正常安全可靠。
5、定期檢查鏈條、手柄、旋鈕、按鍵是否損壞，磨損嚴重的應及時更換，并報備件補充。
6、定期檢查修理開關、保險、手柄、保證其工作可靠。
7、每天下班前10分鐘，對機床加油潤滑及擦洗清潔機床。
8、嚴禁非指定人員操作該設備，平常必須做到人離機停。
A method for maintenance of bending machine
1, strictly follow the operation procedures for operation.
2, every time before the start of the lubrication chart to require the timing, fixed point, quantitative lubricating oil, oil should be clean without precipitation.
3, machine tools must often keep clean, the part of the paint should be coated with rust preventive grease.
4, motor bearing lubrication overflow oil should be changed regularly filling, and always check whether the normal work of safe and reliable electrical parts.
5, regularly check the chain, handle, knob, key press whether damage, wear serious should be replaced, and to spare parts for spare.
6, check the repair switch, insurance, handle, guarantee its work reliably.
10, 7 minutes before work every day, lubrication and cleaning machine tool for machine tools.
8, non designated personnel to operate the device, usually must be done to stop the machine. |
 |
|
手機站
您當前位置是：商業機會 >> 機械及行業設備 >> 機床 >> 馬鞍山力長機械專業生產數控液壓板料折彎機WE67K-100T/3200
聯系信息