廈門SGS提供ASTM C610膨脹珍珠巖模制板狀和管狀絕熱材料測試服務
SGS offer ASTM C610 molded expanded perlite block and pipe thermal insulationTesting Services
Key words: ASTM C610, block, expanded perlite, fittings; molded; pipe, thermal Insulation, thermal conductivity, 膨脹珍珠巖, 模制板, 導熱系數,熱阻, 熱阻測試, 隔熱, 絕熱, 保溫, 絕熱材料, SGS測試
膨脹珍珠巖模制板、配件、管件絕熱材料的主成分通常是膨脹珍珠巖、硅酸鹽粘合劑，可能還含有纖維增強材料。
ASTM C610-15 Standard Specification for Molded Expanded Perlite Block and Pipe Thermal Insulation1
ASTM C610-15 膨脹珍珠巖模制板狀和管狀絕熱材料標準規范1
此規范涵蓋使用表面溫度在80至1200華氏度（27℃至649℃）的膨脹珍珠巖模制板狀、配件、管狀絕熱材料。
ASTM C610-15標準規范中物理性能測試要求及測試標準如下：
ASTM C610 Dimensional tolerances尺寸偏差
ASTM C585 Inner diameter & Outer diameter內徑外徑
ASTM C303 Density of Block insulation 板狀密度
ASTM C302 Procedure A Pipe insulation 管狀密度
ASTM C1045 ASTM C177 block insulation板狀導熱系數
ASTM C335 Apparent thermal conductivity of Pipe insulation 管狀導熱系數
ASTM C356 Linear shrinkage after heat soaking(649℃)線性收縮
ASTM C203 method 1(3 point),procedure D Flexural strength(Block insulation only)彎曲強度(板狀)
ASTM C165 procedure A Compressive resistance(Block insulation only) 抗壓強度(板狀)
ASTM C421 Mass loss by tumbling after 10 minutes 10分鐘翻轉損失
ASTM C1616 Moisture content含水率
ASTM C610 Water absorption after heat aging熱老化后吸水率
ASTM E84 Surface burning characteristics表面燃燒特性
ASTM C411 Hot-surface performance熱面性能(649℃)
ASTM C795 Stress corrosion cracking of austenitic stainless steel應力腐蝕性能
ASTM E136 Non-combustible不燃性 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。