樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/樂泰 3513電子組裝/工業膠水/電子組裝膠水/工業用膠
技術服務熱線：021-51693135 / 021-22818476
樂泰 3513 is a single component, epoxy adhesive
designed for use as a reworkable underfill resin for
CSP(FBGA) or BGA. It cures rapidly on exposure to heat. It is
designed to give excellent protection from failure due to
mechanical stress. The low viscosity allows filling in gaps
under CSP or BGA.
TYPICAL PROPERTIES OF UNCURED MATERIAL
Specific Gravity @ 25 °C 1.15
Viscosity, Cone & Plate, mPa•s (cP),
Temperature: 25 °C, Shear Rate: 36 s
-1:
3,000 to 6,000LMS
Pot life @ 22 °C, hours 48
Flash Point - See SDS
Recommended Curing Conditions
10 minutes @ 150 °C
15 minutes @ 120 °C
30 minutes @ 100 °C
Note: With all fast cure systems, the time required for cure
depends on the rate of heating. Conditions where a hot plate
or heat sink is used are optimum for fastest cure. Cure rates
depend on the mass of material to be heated and intimate
contact with the heat source. Use suggested cure conditions
as general guidelines. Other cure conditions may yield
satisfactory results. Storage
Store product in the unopened container in a dry location. Storage
information may be indicated on the product container labeling.
Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than
8 °C can adversely affect product properties.
樂泰 3513是單組分環氧膠粘劑
設計用作可再加工的底部填充樹脂
CSP（FBGA）或BGA。它在暴露于熱量時迅速治愈。它是
旨 |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。