用于雙光子顯微鏡系統，控制鈦藍寶石激光器光強的電光調制器
關鍵詞：雙光子顯微鏡 電光調制器 Conoptics，雙光子顯微鏡功率調節系統
Conoptics是光學和激光附件制造業的先驅，開發了一套用于多光子顯微鏡的電光調制器。
多光子熒光顯微鏡結合了先進的激光掃描顯微鏡技術，使用紅外波長獲取更高分辨率的三維圖像，多光子熒光顯微鏡是非常實用的研究工具。
Conoptics調制器采用KD*P晶體，光束從中心入射，中心出射，標準的波長范圍從700nm到1100nm。電源使用Model 302RM，擁有1us的上升和下降沿的時間，可作為一個250KHz高速開關，并且可作為一個強度調制器。
調制器參數：
Aperture
3.5mm
Dimensions
50mm Diameter * 135mm
Transmission
>90%
Standard Wavelength Ranges
700-1100nm
Piezo Resonances
Minimal with clamped version(BK option)
Driver Compatibility
Full modulation with M302 Power Amplifier up to 1064nm
放大器參數：
Cabinet
Driver and power supply in single cabinet
Test Feature
Built-in test feature allows testing for max transmission of Pockel Cell with out adjusting bias voltage
DC Bias
Improved DC biasing of Pockel Cell provides greater linearity at higher bias voltages
Voltage Range
+/- 450VDC controlled by ten-turn front panel pot. Digital meter monitors differential bias applied to E.O. Modulator
Linearity
10bits referenced to full scale (.1%)
Bandwidth
DC to >200Khz with 90pf load and 3M (RG-62) cables
Max. Output Drive Level
750VP-P into 90pf load
Amplifier Input Signal
2VP-P max into 50/1K ohms delivers 750VP-P out
Input Signal Format
Options include Unipolar positive, negative or bipolar
Input Power (AC)
60W typical. Input power is both load (modulator) and frequency dependent.
Dimensions
19” Rack Mountable, 5.25”H(133mm) (3U) x 14”D (356mm)
Cooling
Forced air
Operating Environment
Designed for laboratory use (indoor only)
Temperature range +5deg C to +50deg C ambient
Humidity 20%-80% RH up to 32deg C
Altitude <3000M
Weight
20lbs (9.07kg) |
 |
|
手機站
您當前位置是：產品大全 >> 儀器儀表 >>
專用儀器儀表
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。
聯系信息