路博潤ESTANE L194A TPU
Technical Data Sheet Type: L194A is a Shore 95A, polyester grade thermoplastic polyurethane (TPU) Uses: Injection Molding *Test samples were annealed at 100o C and 24 hours at room temperature before testing. **These are typical values and should not be used for specifications. Injection Molding Guide These settings are to be used only as a guide. This is a typical injection molding temperature profile based on the Test Machine (conditions based on a 75 ton machine with a general purpose screw – L/D 17 – ? 35mm). The optimal run conditions for specific equipment will vary depending on the machine and mold design. Drying Conditions Physical Properties Standard No. Units Value Hardness ASTM D2240 Shore A Shore D 94 52 Specific Gravity ASTM D792 g/cm3 1.20 Mechanical Tensile Stress: ASTM D412 kgf/cm2 At *** elongation 140 At 300% elongation 300 Tensile Strength ASTM D412 kgf/cm2 420 Ultimate Elongation ASTM D412 % 440 Tear Resistance (Die C) ASTM D624 kgf/cm 170 Compression Set ASTM D395 At 23°C X22hr % 15 At 70°C X22hr % 40 Mold Shrinkage ASTM D955 m/m 0.008 Thermal Vicat Softening Temperature ASTM D1525 °C 1 |
 |
|
手機站
您當前位置是：產品大全 >> 橡膠塑料 >>
塑料原料
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。
聯系信息
