化糞池模具基本信息/水泥化糞池模具專業生產
保定泰鼎路橋工有限公司，環保性能高，廠家年前大降價，質優價廉，歡迎前來選購。
一、久不滲漏
One, no leakage for a long time
產品池身利用C30鋼筋混凝土、一次成形、密封性好，絕不會產生因
Product pool body using C30 reinforced concrete, once forming, good sealing, will never cause.
地基沉降而引起的斷裂破損和池內板結浮渣層現象，
Fracture damage caused by foundation settlement and Ikeuchi Iyui scum layer phenomenon.
徹底解決了磚砌化糞池污染地下水的問題,保證了化糞池可靠性運行和厭氧化糞的功能。
Thoroughly solved the problem of polluted groundwater by brick septic tanks, ensured the reliable operation of septic tanks and the function of dung oxidation dung.
二、抗壓強度高
Two. High compressive strength
產品結構設計合理，受壓均勻，經多次耐壓測驗，卡車在上部輾壓不沉降，不變形。
The design of the product is reasonable and the pressure is uniform. After many times of pressure test, the truck does not settle and deformation at the top.
三、安裝施工方便
Three. Convenient installation and construction
按圖紙要求挖好基坑，把玻璃鋼化糞池吊入基坑內適當位置，
Dig the foundation pit according to the drawing requirements, and put the fiberglass septic tank into the proper position of the foundation pit.
連接好進出水口，一天內化糞池就可以安裝完畢，且施工不受氣候影響。
Connecting the inlet and outlet well, the septic tank can be installed within a day, and the construction is not affected by the climate.
四、處理效果好
Four. The treatment effect is good
沉淀池內厭氧生物填料和掛膜填料系統的應用，截留了更多的生物量，
The application of anaerobic biofilm and film packing system in the sedimentation tank blocked more biomass.
污水處理能力比同等容積的傳統化糞池提高了一倍以上。
The capacity of sewage treatment is more than doubled than that of conventional septic tanks of the same volume.
五、使用壽命長
Five. Long service life
本產品耐潮濕、耐氧化、高低溫無變形，不畏酸堿，正常使用達50年以上。
This product is resistant to moisture, oxidation resistance, high temperature and no deformation, and is not afraid of acid and alkali. It has been |
 |
|
手機站
您當前位置是：產品大全 >> 五金工具 >>
模具
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。
聯系信息