1、禮品盒包裝出現翹角現象。
1, gift box packaging appears the phenomenon of raised angle.
出現這種情況的主要原因是貼的張數太多，而導致紙板邊沿的膠已干而不能粘住。所以通常應在貼二十張就壓榨較為合適。
The main reason for this is that too many sheets are pasted, leading to the edge of the cardboard adhesive has been dry and can not stick. Therefore, it is usually appropriate to press twenty sheets.
2、禮品盒包裝紙的濕度太大，特別是針對金卡的平貼。
2, the humidity of gift box wrapping paper is too large, especially for gold card.
主要是由于金卡紙對水份的滲透和散失能力很差，而普通的平貼膠其含水量本身較高。所以通常用快干膠或將產品展開置于陽光下晾曬來解決。
It is mainly due to the poor permeability and loss of moisture in gold cardboard, while the plain adhesive has a higher moisture content. So we usually use quick drying glue or expand the product in the sun to solve the problem.
3、所裱瓦或平貼的禮品盒盒，假如在空氣濕度較大的環境下，放置時間稍長會出現變黃等現象。
3. The mounted tiles or flat-pasted gift boxes, if in the air humidity environment, a little longer time will appear yellowing and other phenomena.
主要是由于部分廠家采用了含堿性很大的水玻璃膠或淀粉膠所致。所以為了保證禮品盒包裝的質量我們應該選用質量較好的平貼和瓦楞膠。
The main reason is that some manufacturers use alkaline glass glue or starch glue. Therefore, in order to ensure the quality of gift box packaging, we should use better quality flat paste and corrugated glue.
4、禮品盒包裝出現脫層現象，主要由于粘接劑的強度不夠所致，建議選用一些正規廠家的產品，這樣既能保證強度，減少濕度，增加挺度，又能進步禮品盒包裝產品質量和檔次。
4. The delamination of gift box packaging is mainly due to the insufficient strength of adhesive. It is suggested to select some products from regular manufacturers, which can not only ensure strength, reduce humidity, increase stiffness, but also improve the quality and grade of gift box packaging products.
山東龍徹國際貿易有限公司成立于2015年, 注冊資本501萬元，現已ISO9001質量管理體系認證。是以提供客戶全方位優質服務，是集設計、開發、營銷于一體的綜合性的禮品公司，經營產品涉及電子產品、工藝品、家居紡織日用品、食品及各種不同價位 |
 |
|
手機站
您當前位置是：產品大全 >> 禮品、工藝品 >>
雕刻工藝品
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。
聯系信息
