| USB and HRCAP PLL Module (PLL2)In addition to the main system PLL, these devices also contain a second PLL (PLL2) which can be used toclock the USB and HRCAP peripherals. The PLL supports multipliers of 1 to 15 and has a fixed divide-by-two on its output.PLL2 may be clocked from the following three sources by modifying the PLL2CLKSRCSEL bitsappropriately in the PLL2CTL register:•INTOSC1 (Internal Zero-pin Oscillator 1): This is the on-chip internal oscillator 1 and provides a 10-MHz clock. If used as a clock source for HRCAP, the oscillator compensation routine should be calledfrequently. Because of accuracy requirements, INTOSC1 cannot be used as a clock source for theUSB.•Crystal/Resonator Operation: The (crystal) oscillator enables the use of an external crystal or resonatorattached to the device to provide the time base. The crystal or resonator is connected to the X1/X2pins.•External Clock Source Operation: This mode allows the reference clock to be derived from an externalsingle-ended clock source connected to either GPIO19 or GPIO38. The XCLKINSEL bit in the XCLKregister should be set appropriately to enable the selected GPIO to drive XCLKIN.NOTEFor proper operation of the USB module, PLL2 should be configured to generate a 120-MHzclock. This will be divided by two to yield the desired 60 MHz for the USB peripheral.HRCAP supports a maximum clock input frequency of 120 MH |
 |
|
手機站
您當前位置是：產品大全 >> 電子元器件 >>
集成電路(IC)
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知?jiǎng)h除。
聯系信息
