一個工作周期內混凝土攪拌站主機至少應清洗1次.每天生產結束后,則應對攪拌站主機進行全面的清洗,方法是:在清洗過程中,將水及少許石子放進攪拌主機內攪拌5~10 min,清洗后將機內物料全部清除,不得有積水、積料;停機后再沖洗管道,清除攪拌罐內外灰塵和粘附的混凝土.一般情況下,JS1000型攪拌主機加水約150~180 kg左右,其他型號主機可據此增減,也可自備高壓水槍進行清理.
A working cycle in the concrete mixing station host at least 1 times. The daily production should be cleaned after the end is to thoroughly clean the mixing station host, the method is: in the process of cleaning, water and a few stones into the mixing console in 5~10 min after mixing, cleaning machine material in the water is not clear all. And the accumulation of the material; stop after washing pipe, remove dust and mixing tank and the adhesion of concrete. In general, JS1000 type main mixing water about 150~180 about kg, other types of host can then change, also can bring their own water cannons to clear.
混凝土攪拌站主機日常應該怎樣維護與清理
How to maintain and clean up the main engine of concrete mixing station
在沖洗攪拌主機料門時,應避免上部沖洗下的積料形成異物卡滯料門現象.攪拌過程中,若混凝土運輸車較長時間沒有到位(超過20~30 min,尤其在夏季),應加水對攪拌機進行簡易清洗.
During flushing and mixing main material gate, we should avoid the phenomenon of foreign matter stuck and sluggish door when washing up the upper part. During the mixing process, if the concrete truck is not in place for a long time (over 20~30 min, especially in summer), we should add water to clean the mixer.
混凝土攪拌站設備正常生產期間,要定期檢查攪拌筒內及攪拌軸上混凝土的凝固情況,如有凝結應及時按要求進行人工鏟除.人工清理攪拌筒前,必須切斷電源、氣路,放凈余氣、鎖好控制室;人工清理攪拌筒時,嚴禁猛烈敲擊攪拌軸、攪拌臂及攪拌葉片.
During the normal production of concrete mixing station equipment, to regularly check the mixing barrel and the stirring shaft concrete solidification condition, such as a setting should be timely manual eradication as required. Manual cleaning of mixing drum, must cut off the power supply, gas, gas, put the net lock control room; manual cleaning of mixing drum, non violent a stirring shaft, stirring arm and |
 |
|
手機站
您當前位置是：產品大全 >> 建筑、建材 >>
水泥及制品
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。
聯系信息