HYSOL KL-G150電子膠水/塑封膠水/漢高樂泰膠水/塑封方案
技術服務熱線：021-51693135 / 021-22818476
樂泰 HYSOL KL G150 has been formulated to provide the bestpossible moldability and as wide a molding latitude as possible.
Although molding and curing conditions will vary from situation tosituation, recommended starting ranges are shown above.
TYPICAL PROPERTIES OF CURED MATERIALAll measurements taken at 25 °C unless otherwise noted.
All physical, electrical and analytical measurements taken on specimens curedfor 2 minutes @ 175 °C with post cure of 6 hours at 175 °C, unlessother wise specified.
Physical Properties:Coefficient of Thermal Expansion , ppm/°C:Below Tg 18Above Tg 60Glass Transition Temperature, °C 165
Specific Gravity 1.92StorageStore product in the unopened container in a dry location.Storage information may be indicated on the product containerlabeling.Powder Storage - Powder or preforms should be stored at 5oCor below, in closed containers.
After removal from coldstorage, the material MUST be allowed to come to roomtemperature, in the sealed container, to avoid moisturecontamination.
The suggested waiting time for a standard 15kg carton box is 24 hours
樂泰 HYSOL KL G150已經配制成提供*佳可塑性和盡可能寬的成型緯度。
雖然成型和固化條件將根據情況設置而有所不同，但推薦的起始范圍如上所示。固化材料的特性在25°C下進行所有測量除非另有說明。
所有身體，除非另有規定，否則試樣在175℃下固化2分鐘后進行電氣和分析測量，除非另有規定，物理性能：熱膨脹系數，ppm /℃：低于Tg 18Ab Tg 60玻璃化轉變溫度， °C 165比重1.92儲存產品在未開封的集裝箱中，在干燥的位置。
儲存信息可能在產品容器標簽上顯示。
粉末儲存 - 粉末或預制件應存放在5oC以下，密閉的容器中。
從冷藏箱中取出后，必須在密封容器中使材料達到室溫，以避免水分污染。
標準15kg紙箱的建議等待時間為24小時 |
 |
|
手機站
您當前位置是：產品大全 >> 化工 >>
膠粘劑
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。
10
聯系信息
