章丘市同盛涂裝設備廠
1.給排風的設計不合理, 造成噴漆操作環境排風效果不佳。主要表現是給風過濾系統阻力大、產生負壓、局部有死角。在噴漆作業時反彈漆霧對板件有二次污染現象,對產品質量有一定的影響。
1 to exhaust the design is unreasonable, resulting in poor operation of spray painting operation environment. The main performance is to air filtration system resistance, negative pressure, local dead. There are two phenomena of pollution to the plate during the spray painting operation, which has a certain influence on the quality of the products.
2.片面追求給排風效果, 使給排風風量及風壓過大,從而增加了設備投入和運行費用。尤其對北方的木器生產廠, 冬季還需要加熱送風, 給排風的風機過大, 造成的熱損也就越大, 從而增加了企業生產成本。
2 one-sided pursuit of exhaust effect, so that the exhaust air volume and wind pressure is too large, thus increasing the equipment investment and operating costs. In particular, the north of the wood production plant, the winter also need to heat the air supply to the exhaust fan is too large, resulting in greater heat loss, thus increasing the cost of production.
一般說來, 在設計計算時,吸口風速要求控制在0.05m/s,送風出口的風速控制在0.35m/s,以此選擇風機的機型。
Generally speaking, in the design calculation, the suction mouth wind speed requirements in 0.05m/s, the wind speed of the outlet control in 0.35m/s, in order to select the type of fan.
3. 噴漆房的照明布局不合理、對應的照度不夠, 不能給噴漆提供良好的工作環境, 還有一些企業在漆房的照明上不采用防爆的燈具,給生產帶來嚴重的安全隱患。
3 spray painting room lighting layout is not reasonable, the intensity is not enough, not to paint with good working environment, there are some companies in the paint room lighting on the explosion-proof lamps, bring a serious security risk to production.
章丘市同盛涂裝設備廠(13361064673)，位于濟南市東郊的章丘市辛寨鎮駐地。公司企業法人侯祥平自1990年起從業在涂裝行業。曾在華譽、金城、華豐、興盛等多家烤漆設備廠，生產、安裝、設計、銷售和建廠。由此積累了專業經驗和好多技術過硬的朋友。
章丘市同盛涂裝設備廠自正式注冊成為獨立法人企業時起，同步與業內老朋友單位達成了兄弟合作支持單位。并吸收了大量的專業技術人員。在專業技術人員與員工的努力支持 |
 |
|
手機站
您當前位置是：產品大全 >> 機械及行業設備 >>
其他未分類
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。
聯系信息